Back to Powered Hoist

FD-24
Overspeed Brake Assembly
Hi-Lo Drill

FD-24 Powered Hoist
(205-211) left
(205-212) right

Open Breech Reeving
The FD-24 hoist is renowned for its ease of use, serviceability, and low maintenance cost.
The FD-24 hoist is designed to work with Hi-Lo Climber modular platforms as well as most straightboards. The FD-24 hoist design maintains a high center of gravity which enhances the stability of any attached swingstage.
Power requirements: 110 volt standard. 220 volt and air are also available.
Dimensions: 24"W x 10"D x 54"H. Weight 130 lb.
Speed is 22 feet per minute.
Rated 1000 lb./unit

The FD-24 hoist is designed to work with a large variety of straight boards (platforms) up to 28 inches in width utilizing the included bottom plate assembly.
The FD-24 will conveniently fold down onto the straightboard for transporting.

Bottom plate assembly dimensions: 32" W x 2" D x 6" to 10" H. Weight = 22 lbs.
Overspeed Brake Assembly
Automatically trips and locks the wire rope to the frame should descent speed become excessive.
Back to Powered Hoist

Back to FD-24

Hi-Lo Drill

Hi-Lo Climbers hoist power begins with the rugged Dewalt drill. This drill has been customized by Hi-Lo Climbers to further increase the safety and reliability required for constant outdoor use. The drill can easily be removed and replaced in a few minutes which enhances serviceability and reduces downtime.

Back to Powered Hoist

Back to FD-24

Open Breech Reeving

Open Breech reeving is the fastest method of wire rope installation. Reeving can be done at any point along the wire rope. Reeving from the end of a wire rope is unnecessary with this system. Should a wire rope ever jam inside this unit, the operator can open the reeving mechanism and correct the problem without the safety exposure of cutting the wire rope.

Back to Powered Hoist