Back to Powered Hoist

D 800
Overspeed Brake Assembly
Hi-Lo Drill

D 800 Powered Hoist
(205-101) left
(205-102) right

Open Breech Reeving
The D800 hoist is renowned for its ease of use, serviceability, and low maintenance cost. The D800 hoist design maintains a high center of gravity which enhances the stability of any attached swingstage. The D800 hoist is designed to work with a large variety of straight boards up to 28 inches in width.

Power requirements: 110 volt standard. 220 volt and air are also available.
Dimensions: 32"W x 10"D x 54"H. Weight 131 lb.
Speed is 22 feet per minute.
Rated 1000 lb./unit
spacespacespacespace
Optional Accessory
Stirrip Guardrail Support
(260-007)
Back to Powered Hoist
Overspeed Brake Assembly
Automatically trips and locks the wire rope to the frame should descent speed become excessive.
Back to Powered Hoist
Hi-Lo Drill

Hi-Lo Climbers hoist power begins with the rugged Dewalt drill. This drill has been customized by Hi-Lo Climbers to further increase the safety and reliability required for constant outdoor use. The drill can easily be removed and replaced in a few minutes which enhances serviceability and reduces downtime.

Back to Powered Hoist
Open Breech Reeving

Open Breech reeving is the fastest method of wire rope installation. Reeving can be done at any point along the wire rope. Reeving from the end of a wire rope is unnecessary with this system. Should a wire rope ever jam inside this unit, the operator can open the reeving mechanism and correct the problem without the safety exposure of cutting the wire rope.

Back to Powered Hoist